
56
Pelco-P/D/P1/D1 is different from DH-SD protocol. So please pay attention to the
following instructions.
The operations are as follows:
Click GOTO button to call preset, input preset 28 or 95 to enter dome menu.
Please use up/down to move cursor and left/right to adjust value. Click OPEN
button in keyboard to confirm. (“Open” here is just the same to enter.) Please
refer to the following sheet for more information. Detailed operation instruction
please see chapter 8.
keyboard
PELCO-P/D PELCO-P1/D1
Enter dome
menu
Input preset 28 or 95 Press “MENU”
Move
cursor up
↑ or joystick up ↑ or joystick up
Move
cursor down
↓ or joystick down ↓ or joystick down
ON/OFF
and modify
other setup
← /→ or joystick move left
and right.
← /→ or joystick move left
and right.
Go to sub
menu
OPEN OPEN
Exit sub
menu
Move the cursor to highlight
back and then click OPEN
Move the cursor to
highlight back and then
click OPEN
Exit dome
menu
Move the cursor to highlight
EXIT and then click OPEN
Move the cursor to
highlight EXIT and then
click OPEN
Note:
• When you input preset to enter dome menu, please click ESC on the
keyboard to exit preset menu. Now you can use ↑、 ↓、← 、→or
joystick to move cursor.
• You can only implement dome menu operation after you enter dome menu
setup. Exit dome menu if you wan to control PTZ movement. “Iris Open” is
working as enter button.
9.4 Scan/Tour/Pattern for PELCO-P/D/P1/D1
9.4.1 Via Preset
In dome menu, select PELCO SELECT in device control sub menu.
When PELCO SELECT is OFF (Default): you can set and call presets above 64.
When PELCO SELECT is ON: you can set and call preset value below 32.
9.4.1.1 Operation when PELCO SELECT is OFF
1) Scan
Preset setup Function
92 Set scan left border
93 Set scan right border
79 Begin pattern
80 Stop pattern
Komentáře k této Příručce